[EMS Discuss] Acetone vapor bath for smoothing 3D prints

Bob Miller EMAIL HIDDEN
Tue Feb 26 11:39:55 PST 2013


I wonder whether this would work on ABS.

https://www.youtube.com/watch?v=kRCnVBM3R0c

On Tue, Feb 26, 2013 at 10:41 AM, Ben Hallert - Vipmail <EMAIL HIDDEN> wrote:
> Chuck Edson suggested using a hot plate and thermometer to both free up the printer AND reduce fire hazard by being able to place the vapor setup away from walls without moving the whole printer.
>
> Thought that was a good suggestion, especially if we can keep the temp from getting too hot.
>
> - Ben
>
> On Feb 26, 2013, at 10:10 AM, EMAIL HIDDEN wrote:
>
>>
>> Very cool indeed.  Thanks for forwarding that.  I think I'll try that this week.
>>
>>> That's so cool.  I always thought it would be awesome if you could smooth
>>> out the parts somehow.  Sanding just takes a long time and creates a lot of
>>> dust.  It's also hard to sand tiny corners and small details.  I wonder if
>>> you lose any of the fine details with this method.
>>>
>>>
>>> On Tue, Feb 26, 2013 at 5:14 AM, Ben Hallert <EMAIL HIDDEN> wrote:
>>>
>>>> Saw this interesting post/technique for smoothing 3D prints of ABS and
>>>> removing all 'steps' from the appearance:
>>>>
>>>> http://blog.reprap.org/2013/02/vapor-treating-abs-rp-parts.html
>>>>
>>>> Based on some past discussions we've had at the shop, I figured there
>>>> might be some interest in this here.
>>>>
>>>> - Ben
>>>>
>>>>
>>>>
>>>> _______________________________________________
>>>> Discuss mailing list
>>>> EMAIL HIDDEN
>>>> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss
>>> _______________________________________________
>>> Discuss mailing list
>>> EMAIL HIDDEN
>>> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss
>>
>>
>>
>> _______________________________________________
>> Discuss mailing list
>> EMAIL HIDDEN
>> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss
> _______________________________________________
> Discuss mailing list
> EMAIL HIDDEN
> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss



--
Bob Miller                              K<bob>
                                        EMAIL HIDDEN


More information about the Discuss mailing list