[EMS Discuss] 3d printer with large bed

Kassie EMAIL HIDDEN
Fri Mar 15 11:24:40 PDT 2013


The printrbot has had a little work left to go on it.  It seems that the extrude temperature is off. 130 c as read by the firmware was over the max extrude temp.  I play to work on it a bit more to fix this problem soon.  Also the wades extruded could use a non-essential  repair

Sent from my iPhone

On Mar 15, 2013, at 9:54 AM, Rick Osgood <EMAIL HIDDEN> wrote:

> Also, are you thinking of laser cutting pieces from wood?  A lot of the stuff you could do on a laser cutter can probably be done with a scroll saw.  It will just take a bit more time for you to sit there and do it manually.  We have a nice scroll saw at the shop that you could probably use to cut out your parts.
> 
> 
> On Fri, Mar 15, 2013 at 9:53 AM, Rick Osgood <EMAIL HIDDEN> wrote:
>> Mark left his printrbot at the shop.  The bed is about 8 inches by 8 inches, so not quite as big as you are looking for.  Also, I'm not sure what the status of the printer is since it's not hooked up.  I think some members were working on getting it up and running but I haven't been involved with it so I'm not sure.
>> 
>> 
>> On Fri, Mar 15, 2013 at 8:44 AM, Connor <EMAIL HIDDEN> wrote:
>>> The printer bed would have to be at least 29 CM long a 3d
>>> printer that is this big would be hard to find so a laser
>>> cuter would also work
>>> --
>>> Posted from the Discuss forum
>>> _______________________________________________
>>> Discuss mailing list
>>> EMAIL HIDDEN
>>> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss
> 
> _______________________________________________
> Discuss mailing list
> EMAIL HIDDEN
> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://eugenemakerspace.com/pipermail/com.eugenemakerspace.discuss/attachments/20130315/a85bb4d7/attachment.html>


More information about the Discuss mailing list