[EMS Discuss] 3D printer

Bob Miller EMAIL HIDDEN
Wed Jan 8 16:30:00 PST 2014


Acetone dissolves ABS very slowly.  You'll have better luck if you can
disassemble the hot end and soak the metal parts in acetone.

Otherwise, you can get try scraping the metal surfaces with something
softer than brass.

On Wed, Jan 8, 2014 at 2:09 PM, Mark Danburg-Wyld <EMAIL HIDDEN> wrote:
> If you mean the printrbot, go for it.
>
>
> On Wed, Jan 8, 2014 at 12:23 PM, Mr. Clif <EMAIL HIDDEN> wrote:
>>
>> Sounds good to me but they are not my printers. Depending on which one you
>> are talking about, you might want to contact Rick or Mark.
>>
>>     Clif
>>
>>
>> On 01/08/2014 12:12 PM, Greg Norman wrote:
>>
>> I have used the 3D printer a couple times and it seems the quality of the
>> results are deminishing. On one side of the object being printed and in
>> particular the far corner of that side the filament of plastic is pulled
>> away from its' intended placement.  I suspect a couple possible reasons but
>> don't want to attempt a fix unless the procedure is approved.
>>
>> I suspect the exterior of the print head may be to dirty (old leftover
>> plastic) and the dirt is draging across the plastic stream.
>> I would like to clean the exterior with acetone. Does anyone have a
>> problem with that? I don't think acetone would damage it as long as I keep
>> it off the plastic parts and wire insulation.
>>
>> I also suspect belt tension should be set. Should I do this? I can eyeball
>> it or if we have a spec I can set it to that.
>>
>> Greg Norman
>>
>>
>> _______________________________________________
>> Discuss mailing list
>> EMAIL HIDDEN
>> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss
>>
>>
>>
>> _______________________________________________
>> Discuss mailing list
>> EMAIL HIDDEN
>> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss
>>
>
>
> _______________________________________________
> Discuss mailing list
> EMAIL HIDDEN
> http://eugenemakerspace.com/mailman/listinfo/com.eugenemakerspace.discuss
>



-- 
Bob Miller                              K<bob>
                                        EMAIL HIDDEN


More information about the Discuss mailing list